Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSAUDI2011Q5 QUATTRO (8RB) V6-3.2L (CALB)REPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSTECHNICAL SERVICE BULLETINS
2011 Audi Q5 Quattro (8RB) V6-3.2L (CALB)
Computers and Control Systems: Technical Service Bulletins
2011 Audi Q5 Quattro (8RB) V6-3.2L (CALB)SECTION Technical Service Bulletins
- Recalls
- Customer Interest
- Engine - MIL ON, P0491 and P0492 Stored at Same Time
- Engine - Cam Adjuster, Implausible Signal, MIL ON, DTC's
- A/T - Shift Quality Complaints, 0BK And 0B6 Automatic Gearboxes
- Computers/Control - No Start After CAN Bus Silence
- Engine Controls - MIL ON/DTC's P2440 and P2442 Stored
- Electrical - Erratic/Sporadic DTC's Set
- Interior - Seat Heating Performance Too Low
- By Symptom
- Customer Interest
- Engine - MIL ON, P0491 and P0492 Stored at Same Time
- Engine - Cam Adjuster, Implausible Signal, MIL ON, DTC's
- A/T - Shift Quality Complaints, 0BK And 0B6 Automatic Gearboxes
- Computers/Control - No Start After CAN Bus Silence
- Engine Controls - MIL ON/DTC's P2440 and P2442 Stored
- Electrical - Erratic/Sporadic DTC's Set
- Interior - Seat Heating Performance Too Low
- Hard Shifting
- Recalls
- Starting problems
- Vibration
- Customer Interest
- All Technical Service Bulletins
- Engine - MIL ON, P0491 and P0492 Stored at Same Time
- Engine - Cam Adjuster, Implausible Signal, MIL ON, DTC's
- Campaign 37G1 - TCM Update For Hesitation/Harshness
- A/T - Shift Quality Complaints, 0BK And 0B6 Automatic Gearboxes
- Computers/Control - No Start After CAN Bus Silence
- Engine Controls - Auto Detection Of Unauthorized Chip Tuning
- Engine Controls - MIL ON/DTC's P2440 and P2442 Stored
- Computers/Controls - Software Version Management (SVM)
- Campaign 24U6 - ECM Update For Various Issues
- Fuel System - Fuel Pump/Control Unit Diagnostic Info.
- Campaign 37F8 - TCM Update For Improved Shift Quality
- Campaign 37F5 - TCM Update For Improved Shifting
- Electrical - Erratic/Sporadic DTC's Set
- Interior - Seat Heating Performance Too Low
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.