SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSAUDI2011Q5 QUATTRO (8RB) V6-3.2L (CALB)REPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSRELAYS AND MODULES - COMPUTERS AND CONTROL SYSTEMSBODY CONTROL MODULESERVICE AND REPAIRSPECIAL PURPOSE VEHICLE CONTROL MODULE (J608)
2011 Audi Q5 Quattro (8RB) V6-3.2L (CALB)

Special Purpose Vehicle Control Module (J608)

2011 Audi Q5 Quattro (8RB) V6-3.2L (CALB)SECTION Special Purpose Vehicle Control Module (J608)






Special Purpose Vehicle Control Module (J608)

Removing






- Switch the ignition off.

- Disconnect the battery ground (GND) cable from the battery. Refer to => [ Battery, Disconnecting and Connecting ] Battery, Disconnecting and Connecting.

- Open the cover for the left luggage compartment side trim panel.

- Disconnect the connector - 1 - on the control module.

- Push the clip - 3 - upward and move the special purpose vehicle control module - 2 - in the direction of the - arrow - out of the frame.

Installing

Install in reverse order of removal, observing the following:

- Connect battery. Required actions, refer to => [ Battery, Disconnecting and Connecting ] Battery, Disconnecting and Connecting.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.