Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSAUDI2011Q5 QUATTRO (8RB) V6-3.2L (CALB)REPAIR AND DIAGNOSISMAINTENANCEALIGNMENTSERVICE AND REPAIRPROCEDURESWHEEL ALIGNMENT MEASUREMENT PREPARATIONS
2011 Audi Q5 Quattro (8RB) V6-3.2L (CALB)
Wheel Alignment Measurement Preparations
2011 Audi Q5 Quattro (8RB) V6-3.2L (CALB)SECTION Wheel Alignment Measurement Preparations
Wheel Alignment Measurement Preparations
Special tools, testers and auxiliary items required
• Brake pedal actuator (V.A.G 1869/2)
• Vehicle Diagnostic, Testing and Information System (VAS 5051 B) with corresponding diagnostic cable.
• Wheel alignment computer
• The measurement sensor must be properly adjusted and attached to the vehicle; observe device manufacturer's operating instructions.
• Make sure that the sliding plates and turn tables are not touching the end stop when checking the wheel alignment.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.