Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSAUDI2011Q5 QUATTRO (8RB) V6-3.2L (CALB)REPAIR AND DIAGNOSISDIAGRAMSCONNECTOR VIEWSREAR VISION CAMERA
2011 Audi Q5 Quattro (8RB) V6-3.2L (CALB)
Rear Vision Camera
2011 Audi Q5 Quattro (8RB) V6-3.2L (CALB)SECTION Rear Vision Camera
Connectors, Rearview Camera System Control Module
Rear View Camera System Control Module (J772)
A Black 54-pin connector
B Not used
C FBAS output (green) to information electronics control module 1
D FBAS input (gray) from rear view camera
• Unlisted connector terminals are not assigned.
A - Black 54-Pin Multi-Pin Connector
39 CAN-Bus Low (comfort)
40 CAN-Bus High (comfort)
43 Terminal 30
44 Terminal 31
47 Terminal 31 to rear view camera (R189)
48 Voltage supply rear view camera
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.