Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSAUDI2011Q5 QUATTRO (8RB) V6-3.2L (CALB)REPAIR AND DIAGNOSISBODY AND FRAMESEATSPOWER SEAT CONTROL MODULESERVICE AND REPAIRPOWER STANDARD FRONT SEAT, WITH OR WITHOUT MEMORYMEMORY SEAT/STEERING COLUMN ADJUSTMENT CONTROL MODULE
2011 Audi Q5 Quattro (8RB) V6-3.2L (CALB)
Memory Seat/Steering Column Adjustment Control Module
2011 Audi Q5 Quattro (8RB) V6-3.2L (CALB)SECTION Memory Seat/Steering Column Adjustment Control Module
Memory Seat/Steering Column Adjustment Control Module
Special tools, testers and auxiliary items required
• Removal Wedge (3409)
• Seat Repair Stand (VAS6136)
Removing
• Follow all safety precautions when working on pyrotechnic components.
• Before handling pyrotechnic components (for example, disconnecting the connector), the person handling them must discharge static electricity. For example, by briefly touching the door striker pin.
- Remove the front seat. Refer to => [ Power Standard Front Seat ] Power Standard Front Seat.
- Attach the front seat to the (VAS 6136). Refer to => [ Front Seat, Installing on Seat Repair Stand ] Overhaul.
- Disconnect the connectors - 2 through 5 - on the control module - 1 -.
- Unclip the tabs - arrows - using the (3409).
- Carefully tilt the control module - 1 - in the - direction of arrow B - out of the retainers - 2 -.
- Slide the control module in the - direction of arrow A -.
- Disengage the tabs - arrow - from the control module bracket.
- Remove the control module from the bracket.
Installation
• Follow all safety precautions when working on pyrotechnic components.
• Before handling pyrotechnic components (for example, connecting electrical connector), the person handling them must discharge static electricity. For example, by briefly touching the door striker pin.
Installation is reverse of removal, but note the following:
• Make sure the memory seat adjustment control module engages audibly in the retainer.
• Make sure the connectors are installed all the way in and are secure.
Connect the battery with the ignition switched on. Pyrotechnic components could deploy after connecting the battery if they were not repaired correctly. Individuals must not be inside the vehicle when connecting the battery.
- Connect the battery ground cable with the ignition turned on.
• If the airbag indicator lamp (K75) indicates a fault after installation, the DTC memory must be checked, deleted and checked again using the Vehicle diagnostic tester.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.