Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSAUDI2011Q5 QUATTRO (8RB) V6-3.2L (CALB)REPAIR AND DIAGNOSISBODY AND FRAMERELAYS AND MODULES - BODY AND FRAMEPOWER SEAT CONTROL MODULESERVICE AND REPAIRDRIVER MEMORY SEAT CONTROL HEAD (E97)
2011 Audi Q5 Quattro (8RB) V6-3.2L (CALB)
Driver Memory Seat Control Head (E97)
2011 Audi Q5 Quattro (8RB) V6-3.2L (CALB)SECTION Driver Memory Seat Control Head (E97)
Driver Memory Seat Control Head (E97)
Removing
- Remove the front door trim panel. Refer to => [ Front Door Trim ] Front Door Trim.
- Remove the driver memory seat control head.
- Release the switch trim - 1 - first at the top - arrows A - and then forward and out of the door panel.
Installation
Installation is reverse of removal, but note the following:
- First insert the switch trim at the bottom - arrows B - and then press it in until it audibly locks in place.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.