Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSAUDI2011Q5 QUATTRO (8RB) V6-3.2L (CALB)REPAIR AND DIAGNOSISBODY AND FRAMEMIRRORSSERVICE AND REPAIRPROCEDURES
2011 Audi Q5 Quattro (8RB) V6-3.2L (CALB)
Procedures
2011 Audi Q5 Quattro (8RB) V6-3.2L (CALB)SECTION Procedures
Automatic-Dimming Function, Switching On and Off
Switching On and Off
- Press the button quickly (less than 3 seconds) - 1 - to switch the automatic dimming function on or off.
Automatic dimming "ON": the lamp in the display - 2 - comes on.
Automatic dimming "OFF": the lamp in the display - 2 - goes out.
• Automatic dimming function is activated each time ignition is switched on.
• If the automatic dimming function is deactivated, the function is also deactivated on the exterior rearview mirror.
• In dimming mode, mirror surface lights up when interior lights are switched on or reverse gear is engaged.
• Note that the interior rearview mirror automatic dimming function can only work properly if the rear window sun shade is raised.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.