Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSAUDI2006A4 QUATTRO SEDAN (8EC) V6-3.2L (BKH)REPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSTHROTTLE POSITION SENSORSERVICE AND REPAIR
2006 Audi A4 Quattro Sedan (8EC) V6-3.2L (BKH)
Throttle Position Sensor: Service and Repair
2006 Audi A4 Quattro Sedan (8EC) V6-3.2L (BKH)SECTION Service and Repair
Accelerator Pedal Module With Throttle Position (TP) Sensors, Removing And Installing
Removing
- Remove driver side storage tray.
- Disconnect electrical connector - 2 -.
- Remove bolts - 1 - and - 3 -.
- Remove accelerator pedal module.
Installing
Installation is in reverse order of removal. Note the following:
- Install driver side storage tray.
Vehicles with automatic transmission:
- On vehicles with automatic transmission, the kick-down function must be adapted if the throttle position sensor or engine control module are replaced.
Torque specifications
Accelerator pedal module to pedal mount 10 Nm
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.