Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSACURA1998NSX V6-3.2L DOHC (VTEC)REPAIR AND DIAGNOSISRELAYS AND MODULESRELAYS AND MODULES - BRAKES AND TRACTION CONTROLTRACTION CONTROL MODULESERVICE AND REPAIR
1998 Acura NSX V6-3.2L DOHC (VTEC)
Traction Control Module: Service and Repair
1998 Acura NSX V6-3.2L DOHC (VTEC)SECTION Service and Repair
1. Remove the left rear trim panel and rear upper trim panel.
2. Remove the wire harness bracket.
3. Disconnect the Traction Control System (TCS) control unit connectors.
4. Remove the TCS control unit.
5. Install the TCS control unit in the reverse order of removal.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.