Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSACURA1998NSX V6-3.2L DOHC (VTEC)REPAIR AND DIAGNOSISMAINTENANCEALIGNMENTSERVICE AND REPAIRTURNING ANGLE
1998 Acura NSX V6-3.2L DOHC (VTEC)
Turning Angle
1998 Acura NSX V6-3.2L DOHC (VTEC)SECTION Turning Angle
NOTE: Place a vehicle on a level surface before inspection. Release the parking brake and be sure that the vehicle is empty. Check that the suspensions are at the standard height.
1. Turn the steering wheel fully to the right and left while applying the brake, and measure the turning angle of both wheels.
- Turning angle: Inward: 33°06' ± 2°.
- Outward: 26°34' (Reference value).
2. If the measurements are not within the specifications or if the inward turning angles differ between the right and left, check the toe and adjust accordingly.
3. If the toe adjustment is within specifications, and turning angle is still off, check for bent or damaged suspension components.
1. Turn the steering wheel fully to the right and left while applying the brake, and measure the turning angle of both wheels.
- Turning angle: Inward: 33°06' ± 2°.
- Outward: 26°34' (Reference value).
2. If the measurements are not within the specifications or if the inward turning angles differ between the right and left, check the toe and adjust accordingly.
3. If the toe adjustment is within specifications, and turning angle is still off, check for bent or damaged suspension components.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.