Accessory DC Power Control Module Programming and Setup
This is the exact OEM manual section for the path above. Use the breadcrumb to move up or down the tree until you reach the precise year, make, model, and subsystem you need.
Need a step-by-step guide?
Get an AI-powered repair guide with parts lists, cost estimates, and clear instructions for your GMC Truck hyperlink.
Revenue RailIntent: manual
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
More supporting gear
Torque wrench
Use the factory procedure with the right tightening tool.
Manual-based work becomes much easier when you can torque correctly.
Shop on Amazon →Trim tool set
Useful for clips, covers, and trim pieces called out by the manual.
Most manual procedures assume you have a good trim removal kit.
Shop on Amazon →Multimeter kit
Great for electrical troubleshooting and manual-tested circuits.
Electrical work in manuals often needs a meter more than another wrench.
Shop on Amazon →Accessory DC Power Control Module Programming and Setup
The following service procedures require either a programming or a setup event be performed for a complete repair.
Accessory Power Module (APM) Replacement
If the APM is replaced, APM programming must be performed. Refer to Service Programming System (SPS) Service Programming System (SPS).
Accessory Power Module (APM) Reprogramming
When APM reprogramming must be performed, refer to Service Programming System (SPS) Service Programming System (SPS).
Ensure the following conditions exist in order to prepare for APM programming or reprogramming:
* The battery is fully charged.
* The ignition switch is in the RUN position.
* The Techline equipment cable connection at the data link connector (DLC) is secure.
Program the APM using the latest software matching the vehicle. Refer to up-to-date Techline equipment user instructions.
If the APM fails to program, proceed as follows:
* Ensure the DLC and APM connections are good.
* Inspect the Techline equipment for the latest software version.
* Attempt to program the APM. If the APM still cannot be programmed properly, replace the APM.
Accessory Power Module (APM) Setup
This device requires no setup.