Pinpoint Test H: DTCs U1000:00
This is the exact OEM manual section for the path above. Use the breadcrumb to move up or down the tree until you reach the precise year, make, model, and subsystem you need.
Need a step-by-step guide?
Get an AI-powered repair guide with parts lists, cost estimates, and clear instructions for your Ford hyperlink.
Revenue RailIntent: manual
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
More supporting gear
Torque wrench
Use the factory procedure with the right tightening tool.
Manual-based work becomes much easier when you can torque correctly.
Shop on Amazon →Trim tool set
Useful for clips, covers, and trim pieces called out by the manual.
Most manual procedures assume you have a good trim removal kit.
Shop on Amazon →Multimeter kit
Great for electrical troubleshooting and manual-tested circuits.
Electrical work in manuals often needs a meter more than another wrench.
Shop on Amazon →Remote Function Actuator (RFA) Module
Pinpoint Test H: DTCs U1000:00
Normal Operation
- DTC U1000:00 (Solid State Driver Protection Active - Driver Disabled: No Sub Type Information)- a continuous DTC that sets when the RFA (Remote Function Actuator) module has disabled an output circuit due to a repetitive fault causing a circuit overload.
This pinpoint test is intended to diagnose the following:
- Output circuit short to ground or voltage
- RFA (Remote Function Actuator) module
PINPOINT TEST H : DTCs U1000:00
H1 REVIEW THE DTCs
- Review the DTCs from the RFA (Remote Function Actuator) module self-test.
Are any other DTCs besides U1000:00 or U3000:49 present?
Yes
REFER to Diagnostic Trouble Code (DTC) Chart Body Control Systems/ Body Control Module. After the repair, GO to H2.
No
GO to H2.
H2 CARRY OUT THE RFA (Remote Function Actuator) MODULE SELF-TEST
- Carry out the RFA (Remote Function Actuator) module self-test.
Is only DTC U3000:49 present?
Yes
INSTALL a new RFA (Remote Function Actuator) module. REFER to Remote Function Actuator (RFA) Module . TEST the system for normal operation.
No
The system is operating correctly at this time. The concern was caused by a short from an output circuit.