Remote Control Door Lock Receiver Programming and Setup
This is the exact OEM manual section for the path above. Use the breadcrumb to move up or down the tree until you reach the precise year, make, model, and subsystem you need.
Need a step-by-step guide?
Get an AI-powered repair guide with parts lists, cost estimates, and clear instructions for your Chevrolet hyperlink.
Revenue RailIntent: manual
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
More supporting gear
Torque wrench
Use the factory procedure with the right tightening tool.
Manual-based work becomes much easier when you can torque correctly.
Shop on Amazon →Trim tool set
Useful for clips, covers, and trim pieces called out by the manual.
Most manual procedures assume you have a good trim removal kit.
Shop on Amazon →Multimeter kit
Great for electrical troubleshooting and manual-tested circuits.
Electrical work in manuals often needs a meter more than another wrench.
Shop on Amazon →Remote Control Door Lock Receiver Programming and Setup
Remote Control Door Lock Receiver Replacement
If the remote control door lock receiver is replaced, the following procedures must be performed:
1. RCDLR Programming - Refer to Service Programming System (SPS). Programming and Relearning
2. Keyless Entry Transmitter Programming - Refer to Transmitter Programming. Programming and Relearning
3. Tire Type Setup:
1. Install a scan tool.
2. Select Remote Control Door Lock Receiver under Module Setup in the Vehicle Control System menu.
3. Select Tire Type/Pressure Selection.
4. Follow the on-sceen instructions.
4. Tire Pressure Monitoring Sensor Learn - Refer to Tire Pressure Sensor Learn.
Replacing Keyless Entry Transmitters
If a keyless entry transmitter is replaced, the following procedure must be performed:
Keyless Entry Transmitter Programming-Refer to Transmitter Programming. Programming and Relearning