Engine Control Module Programming and Setup
Need a step-by-step guide?
Get an AI-powered repair guide with parts lists, cost estimates, and clear instructions for your Chevrolet hyperlink.
Revenue RailIntent: manual
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
Engine Control Module Programming and Setup
The following service procedures require either a programming or a setup event be performed for a complete repair.
ECM Replacement
If the engine control module (ECM) is replaced, the following procedures must be performed:
1. ECM Reprogramming-Refer to Service Programming System (SPS). Programming and Relearning
2. Crankshaft Position (CKP) Variation Learn-Refer to Crankshaft Position System Variation Learn.
ECM Reprogramming
If the ECM needs to be reprogrammed, refer to Service Programming System (SPS). Programming and Relearning
Setup for Component Replacement
The replacement of some components will require a setup procedure for complete repair.
If any of the following components are replaced, a CKP Variation Learn Procedure must be performed. Refer to Crankshaft Position System Variation Learn.
* Engine replacement
* Any engine repair that disturbs the CKP sensor or it's relationship with the crankshaft reluctor wheel
* CKP sensor