Connector control module for Anti-lock Brake System Module (ABS), repair
Special tools: 951 2630 Terminal removal tool 951 2630 Terminal Removal Tool , 951 2631 Terminal removal tool 951 2631 Terminal Removal Tool.
Note! As the illustrations in this service information are used for different model years and/or models, some variation may occur. However, the essential information in the illustrations is always correct.
Connector, dismantling
Secondary lock
Slide the catch in the direction of the arrow, as illustrated.
Caution! Disconnect and work with only one cable at a time to minimize the risk of mixing them up.
Primary lock
Use tools 951 2630 Terminal removal tool 951 2630 Terminal Removal Tool and 951 2631 Terminal removal tool 951 2631 Terminal Removal Tool to remove the primary lock, as illustrated.
At the same time pull the cable carefully backwards.
Connector, assembling
Note! Wheel sensor cables are twisted pair (positive and negative signal) cables for each wheel. It is important that paired cables are twinned in the same way when they are reinstalled in the connector. The cables must be twisted approximately 3 times per 100 mm.
Primary lock
Check that the cable terminal is undamaged.
Press the cable terminal into the housing.
Check that the cable terminal is properly locked by pulling carefully on the cable.
Secondary lock
Slide the catch in the direction of the arrow, as illustrated.