Ignition Discharge Module
IMPORTANT: Before replacing the ignition discharge module, carry out Extended ignition discharge module diagnose for Trionic 7.
To remove
1. Unplug the 10-pin ignition discharge module connector.
2. Remove the 4 screws.
3. Lift up the module.
To fit
1. Apply Krytox (part no. 30 19 312) to the rubber seals and fit the ignition discharge module.
2. Fit the 4 screws.
Tightening torque 11 Nm (8.1 lbf ft)
3. Spray the 10-pin ignition discharge module connector with Kontakt 61 (part no. 30 04 520). Plug in the connector.