13-Step B, Injector Control Circuit
Need a step-by-step guide?
Get an AI-powered repair guide with parts lists, cost estimates, and clear instructions for your 1985 Plymouth.
1. With air cleaner removed and diagnostic read-out tool connected to engine test connector, place ignition switch in the OFF position.
2. Disconnect white electrical connector from logic module.
3. Connect fuel injector electrical connector.
4. Place ignition switch in the RUN position, then depress diagnostic read-out tool ATM button.
5. If fuel is now being sprayed from the fuel injector, replace [1][2]power module.
6. If fuel is not being sprayed from fuel injector, replace logic module. Prior to replacing logic module, check for excessive fuel pressure.