Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
61 35 285 Removing and installing (replacing) light module
Necessary preliminary tasks:
- Remove TRIM PANEL FOR PEDAL ASSEMBLY .
Unlock plug connections (2) and (4) and disconnect.
Release screws (1), feed out light module (3) in direction of arrow and remove.
Installation:
Make sure guides (1) of light module (2) are correctly seated in associated mountings.
Replacement:
Carry out programming/coding. Refer to DIAGNOSIS PROGRAMMING/CODING .
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.