Tightening and Torques Sequences

Need a step-by-step guide?

Get an AI-powered repair guide with parts lists, cost estimates, and clear instructions for your 2010 Honda.

Rotate the crankshaft clockwise, and seat the journals into connecting rod No. 2 and connecting rod No. 3. Line up the mark on the connecting rod and the cap, then install the caps and the bolts finger-tight.

Torque the connecting rod bolts to 20 N-m (2.0 kgf-m, 14 lbf-ft).
Tighten the connecting rod bolts an additional 90 °.

← Back to Connecting Rod, Engine All Makes