SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHONDA2006PILOT EX, 3.5 YF2, J35Z1REPAIR AND DIAGNOSISBODY & FRAMEWINDOWSPOWER WINDOWSDRIVER'S WINDOW MOTOR TEST
2006 Honda Pilot EX, 3.5 YF2, J35Z1

Driver's Window Motor Test

2006 Honda Pilot EX, 3.5 YF2, J35Z1SECTION Driver's Window Motor Test

Motor Test 

  1. Remove the driver's door panel (see FRONT DOOR PANEL REMOVAL/INSTALLATION ).
  2. Disconnect the 6P connector (A) from the window motor.
    Fig 1: Disconnecting 6P Connector From Window Motor
    G04247332Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Test the motor in each direction by connecting battery power and ground according to Fig 2. When the motor stops running, disconnect one lead immediately.
    Fig 2: Connecting Battery Power & Ground Table
    G04247333Courtesy of AMERICAN HONDA MOTOR CO., INC.
  4. If the motor does not run or does not run smoothly, replace it.

    5. Pulser Test 

  5. Reconnect the 6P connector to the window motor.
  6. Check for voltage between the terminals.
    • There should be battery voltage between the No. 6 (+) and No. 4 (-) terminals when the ignition switch is ON (II).
    • Connect an analog voltmeter between the No. 5 (+) and No. 4 (-) terminals, and run the window motor at down or up. The voltmeter needle should move back and forth alternately (a digital voltmeter should show the average voltage between 0-5 V).
    • Connect an analog voltmeter between the No. 3 (+) and No. 4 (-) terminals, and run the window motor at down or up. The voltmeter needle should move back and forth alternately (a digital voltmeter should show the average voltage between 0-5 V).
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.