Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHONDA2006PILOT EX, 3.5 YF1, J35Z1REPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMEWINDOWSPOWER WINDOWSPASSENGER'S POWER WINDOW SWITCH TEST/REPLACEMENT
2006 Honda Pilot EX, 3.5 YF1, J35Z1
Passenger's Power Window Switch Test/Replacement
2006 Honda Pilot EX, 3.5 YF1, J35Z1SECTION Passenger's Power Window Switch Test/Replacement
- Carefully pry off the door switch trim (see FRONT DOOR PANEL REMOVAL/INSTALLATION ).
- Disconnect the 6P connector (A) from the power window switch (B), then remove the three mounting screws and the power window switch from the switch trim (C).
Front Passenger's:
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Rear:
- Swap the window switch with another known-good switch and test. If the original window switch is faulty, replace it.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.