Pinpoint Test J: DTC U1000:00

This is the exact OEM manual section for the path above. Use the breadcrumb to move up or down the tree until you reach the precise year, make, model, and subsystem you need.

Need a step-by-step guide?

Get an AI-powered repair guide with parts lists, cost estimates, and clear instructions for your 2012 Ford.

AI Repair Guides
Revenue RailIntent: manual

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

More supporting gear

Torque wrench

Use the factory procedure with the right tightening tool.

Manual-based work becomes much easier when you can torque correctly.

Shop on Amazon →

Trim tool set

Useful for clips, covers, and trim pieces called out by the manual.

Most manual procedures assume you have a good trim removal kit.

Shop on Amazon →

Multimeter kit

Great for electrical troubleshooting and manual-tested circuits.

Electrical work in manuals often needs a meter more than another wrench.

Shop on Amazon →



Remote Function Actuator (RFA) Module

Pinpoint Test J: DTC U1000:00

Normal Operation

- DTC U1000:00 (Solid State Driver Protection Active - Driver Disabled: No Sub Type Information)- sets when the RFA (Remote Function Actuator) module has disabled a circuit due to a repetitive circuit overload and a progressive threshold is met.

This pinpoint test is intended to diagnose the following:

- Output circuit short

- RFA (Remote Function Actuator) module

PINPOINT TEST J : DTC U1000:00

J1 REVIEW THE DTCs

- Review the DTCs from the RFA (Remote Function Actuator) module self-test.

Are any other DTCs present, besides U1000:00 or U3000:49?

Yes
REFER to the Remote Function Actuator (RFA) Module DTC chart Remote Function Actuator (RFA) Module.

No
GO to J2.

J2 REPEAT THE RFA (Remote Function Actuator) MODULE SELF-TEST

- Ignition ON.

- Enter the following diagnostic mode on the scan tool: RFA (Remote Function Actuator) Module Self-Test.

- Clear the DTCs and repeat the RFA (Remote Function Actuator) module self-test.

Is DTC U3000:49 present?

Yes
INSTALL a new RFA (Remote Function Actuator) module. REFER to Remote Function Actuator (RFA) Module . TEST the system for normal operation.

No
The system is operating correctly at this time. The circuit short has been repaired.

← Back to Remote Function Actuator (RFA) ModuleAll Makes