Pinpoint Test F: DTC U1000:00
This is the exact OEM manual section for the path above. Use the breadcrumb to move up or down the tree until you reach the precise year, make, model, and subsystem you need.
Need a step-by-step guide?
Get an AI-powered repair guide with parts lists, cost estimates, and clear instructions for your 2012 Ford.
Revenue RailIntent: manual
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
More supporting gear
Torque wrench
Use the factory procedure with the right tightening tool.
Manual-based work becomes much easier when you can torque correctly.
Shop on Amazon →Trim tool set
Useful for clips, covers, and trim pieces called out by the manual.
Most manual procedures assume you have a good trim removal kit.
Shop on Amazon →Multimeter kit
Great for electrical troubleshooting and manual-tested circuits.
Electrical work in manuals often needs a meter more than another wrench.
Shop on Amazon →Body Control Module (BCM)
Pinpoint Test F: DTC U1000:00
Normal Operation
- DTC U1000: 00 (Solid State Driver Protection Activated - Driver Disabled: No Sub Type Information)- sets when the Body Control Module (BCM) has disabled a circuit due to a repetitive circuit overload and a progressive threshold is met.
The BCM (Body Control Module) controls the output of several vehicle systems by means of solid state drivers. When an overload occurs on any of these drivers, a DTC sets. The module also tracks the number of repetitive faults on each of these circuits. The module compares this number of overloads to 3 progressive thresholds established for each circuit.
At the each threshold, DTC U1000:00 sets along with the DTC associated with the affected circuit.
This pinpoint test is intended to diagnose the following:
- Output circuit short
- BCM (Body Control Module)
PINPOINT TEST F : DTC U1000:00
F1 REVIEW THE DTCs
- Review the DTCs from the BCM (Body Control Module) self-test.
Are any other DTCs present, besides U1000:00 or U3000:49?
Yes
REFER to the Body Control Module (BCM) DTC chart Body Control Module (BCM).
No
GO to F2.
F2 REPEAT THE BCM (Body Control Module) SELF-TEST
- Ignition ON.
- Enter the following diagnostic mode on the scan tool: BCM (Body Control Module) Self-Test.
- Clear the DTCs and repeat the BCM (Body Control Module) self-test.
Is DTC U3000:49 present?
Yes
INSTALL a new BCM (Body Control Module). REFER to Body Control Module (BCM) . TEST the system for normal operation.
No
The system is operating correctly at this time. The circuit short has been repaired.