Knock Sensor: Service and Repair

Need a step-by-step guide?

Get an AI-powered repair guide with parts lists, cost estimates, and clear instructions for your 2007 Ford.

AI Repair Guides
KNOCK SENSOR (KS)







Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Disconnect the battery ground cable.







3. Position the knock sensor (KS) heat shield aside.
4. Disconnect the KS electrical connector.
5. Remove the bolt and the KS.
- To install, tighten to 20 Nm (15 lb-ft).

6. To install, reverse the removal procedure.
← Back to Knock SensorAll Makes