Crankshaft Position Sensor: Service and Repair

Need a step-by-step guide?

Get an AI-powered repair guide with parts lists, cost estimates, and clear instructions for your 2007 Ford.

AI Repair Guides
CRANKSHAFT POSITION (CKP) SENSOR







Removal and Installation
1. With vehicle in NEUTRAL, position it on a hoist.
2. Disconnect the battery ground cable.
3. Remove the 7 pin-type retainers and the RH splash shield.
4. Disconnect the crankshaft position (CKP) sensor electrical connector.
5. Remove the bolt and the CKP sensor.
- To install, tighten to 10 Nm (89 lb-in).

6. To install, reverse the removal procedure.
← Back to Crankshaft Position SensorAll Makes