Piston Ring, Engine

Need a step-by-step guide?

Get an AI-powered repair guide with parts lists, cost estimates, and clear instructions for your 2001 Ford.

Ring gap position: The piston ring gaps must be distributed evenly around the circumference of the piston, This also applies to the oil scraper ring elements. Align the ring gaps at 120 degrees to each other.

Piston Rings Gaps (installed)	Upper Compression Ring	0,30 - 0,50 Millimeter (mm)
	Lower Compression Ring	0,30 - 0,50 Millimeter (mm)
	Oil Scraper Ring	0,40 - 1,40 Millimeter (mm)

← Back to Cylinder Block Assembly All Makes