Hard Starting
Need a step-by-step guide?
Get an AI-powered repair guide with parts lists, cost estimates, and clear instructions for your 1991 Dodge.
Engine cranks OK, but does not start immediately. Will eventually start and run, but may die shortly after.
SYSTEM OR COMPONENT TO CHECK ACTION
COMPUTER INPUTS/OUTPUTS CHECK: - COOLANT TEMPERATURE SENSOR (CTS):
Using a "Scan" tool compare coolant temperature
with ambient temperature on a cold engine.
If coolant temperature reading is 5 degrees
more than or less than ambient air temperature
on a cold engine, check for high resistance in
coolant sensor circuit or sensor itself.
- THROTTLE POSITION SENSOR (TPS):
If a sticking throttle shaft or binding linkage
causes a high TPS voltage (open throttle
indication), the ECU will not control idle.
Monitoring TPS voltage, a "Scan" tool and/or
voltmeter should read less than 1.25 volts
with throttle closed.
- IDLE SPEED MOTOR.
- NO CRANK SIGNAL.
FUEL CHECK: - FUEL PRESSURE
- WATER CONTAMINATED FUEL
- FAULTY IN-TANK FUEL PUMP CHECK VALVE:
This could allow the fuel in the lines to drain
back to the tank after the engine is stopped.
To check for this condition:
1. Ignition "OFF."
2. Disconnect fuel line at the filter.
3. Remove the tank filler cap.
4. Connect a radiator test pump to the fuel line
and apply 103 kPa (15 psi) pressure.
If the pressure will hold for 60 seconds,
the check valve is OK.
IGNITION CHECK: - Proper ignition voltage output with
appropriate spark tester.
- Spark plugs, wet plugs, cracks, wear,
improper gap, burned electrodes or
heavy deposits.
- Bare and shorted wires.
- Moisture in distributor cap.
- Worn distributor shaft.
- Pickup coil connections.
NOTE: If engine starts, then immediately stalls,
disconnect the set timing connector. If engine
then starts, and runs OK, replace distributor
pickup coil.
EMISSIONS CHECK: - EGR SYSTEM: Valve operation.
NOTE: Refer to EMISSION CONTROLS for testing procedures.