DR-2C MAP Sensor Signal Circuit to Logic Module

Need a step-by-step guide?

Get an AI-powered repair guide with parts lists, cost estimates, and clear instructions for your 1987 Dodge.

AI Repair Guides

1. With diagnostic read-out tool connected to engine harness connector, MAP sensor connector disconnected and system in Sensor Test Mode 08, connect a jumper wire between dark green/red wire and black/light blue wire of MAP sensor harness connector. Note that display readings must be divided by 10.
2. If display reads zero volts, proceed to Test 2 step E. DR-2E Checking 5 Volt Supply to MAP Sensor
3. If display does not read zero volts, proceed to Test 2 step D. DR-2D MAP Sensor Wires to Logic Module






← Back to Driveability (DR) TestsAll Makes