A. Replace PCM - LH Vehicles

This is the exact OEM manual section for the path above. Use the breadcrumb to move up or down the tree until you reach the precise year, make, model, and subsystem you need.

Need a step-by-step guide?

Get an AI-powered repair guide with parts lists, cost estimates, and clear instructions for your 2003 Chrysler.

AI Repair Guides
1. Disconnect the negative battery cable.

NOTE:
To enhance customer satisfaction, remember to reset the clock when you have completed the service procedure.

2. Remove the speed control servo and set it aside.

3. Remove the washer fluid bottle filler neck bolt and set the filler neck aside.





4. Disconnect the four (4) PCM electrical connectors and set the wiring harness aside (Figure 1).

5. Remove the three (3) PCM bolts, then remove the PCM and discard it (Figure 1).

6. Install the new PCM. Tighten the mounting bolts to 35 in-lbs (4 N.m) (Figure 1).

7. Connect the four (4) PCM electrical connectors (Figure 1).

8. Install the washer fluid bottle filler neck. Tighten the bolt securely.

9. Install the speed control servo. Tighten the servo bracket bolts securely.

10. Connect the negative battery cable.

11. Continue with Section E - PCM/Vehicle Data Set-up.
Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro
← Back to Service ProcedureAll Makes

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.