P1297 No Change In MAP Sensor From Start to Run
Need a step-by-step guide?
Get an AI-powered repair guide with parts lists, cost estimates, and clear instructions for your 1999 Chrysler.
P-1297 NO CHANGE IN MAP SENSOR FROM START TO RUN
WHEN MONITORED
With engine rpm above 400 but less than 1500 and the throttle body at closed throttle.
SET CONDITION
Too small a difference is seen between barometric pressure at ignition on and manifold vacuum (engine running for 1.76 seconds).
POSSIBLE CAUSES
- MAP sensor wiring harness intermittent defect
- MAP sensor 5-volt supply circuit open
- Vacuum ports restricted or defective
- MAP sensor restricted
- MAP sensor defective (change present)
- MAP sensor defective (no change present)