Control Solenoid Valve and Transmission Control Module Assembly Inspection

This is the exact OEM manual section for the path above. Use the breadcrumb to move up or down the tree until you reach the precise year, make, model, and subsystem you need.

Need a step-by-step guide?

Get an AI-powered repair guide with parts lists, cost estimates, and clear instructions for your 2013 Chevrolet.

AI Repair Guides
Revenue RailIntent: manual

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

More supporting gear

Torque wrench

Use the factory procedure with the right tightening tool.

Manual-based work becomes much easier when you can torque correctly.

Shop on Amazon →

Trim tool set

Useful for clips, covers, and trim pieces called out by the manual.

Most manual procedures assume you have a good trim removal kit.

Shop on Amazon →

Multimeter kit

Great for electrical troubleshooting and manual-tested circuits.

Electrical work in manuals often needs a meter more than another wrench.

Shop on Amazon →



Control Solenoid Valve and Transmission Control Module Assembly Inspection





1. Inspect the control solenoid valve assembly connectors and pins (1, 2, 4, 6) for the following conditions:

* Damage

* Bent pins

* Debris

* Broken retaining tab

* Contamination

2. Ensure no metallic debris is inside the connectors near the terminal pins.

3. Inspect the control solenoid valve assembly solenoid leads (3) for contamination or metallic debris.

4. Inspect the 4 control solenoid valve assembly filter plate retaining tabs (5) for cracks and ensure proper tension when filter plate is attached.

← Back to Component Tests and General DiagnosticsAll Makes