Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

Fuel Level Sensor: Service and Repair

This is the exact OEM manual section for the path above. Use the breadcrumb to move up or down the tree until you reach the precise year, make, model, and subsystem you need.

Need a step-by-step guide?

Get an AI-powered repair guide with parts lists, cost estimates, and clear instructions for your 2013 Chevrolet.

AI Repair Guides

Fuel Level Sensor Replacement

Removal Procedure

Warning: Refer to Gasoline/Gasoline Vapors Warning Service Precautions.

Warning: Refer to Safety Goggles and Fuel Warning Safety Goggles and Fuel Warning.

Caution:
Use care while handling the fuel sender to prevent damage and incorrect fuel level readings.

1. Remove the fuel tank fuel pump module. Refer to Fuel Tank Fuel Pump Module Replacement Fuel Tank Fuel Pump Module Replacement.

2. Disconnect the fuel level sensor wiring harness plug (2) from the fuel tank fuel pump module.

3. Unclip the 2 fuel level sensor retainer pins (4) from the fuel level sensor retainer pin holes (3).

4. Remove the fuel level sensor (1) from the fuel tank fuel pump module.

Installation Procedure

1. Install the fuel level sensor (1) to the fuel tank fuel pump module.

2. The fuel level sensor retainer pins (4) must engage audibly in the fuel level sensor retainer pin holes (3).

3. Connect the fuel level sensor wiring harness plug (2) to the fuel tank fuel pump module.

4. Install the fuel tank fuel pump module. Refer to Fuel Tank Fuel Pump Module Replacement Fuel Tank Fuel Pump Module Replacement.

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

← Back to Fuel Level Sensor All Makes

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.