Disassembled Views

This is the exact OEM manual section for the path above. Use the breadcrumb to move up or down the tree until you reach the precise year, make, model, and subsystem you need.

Need a step-by-step guide?

Get an AI-powered repair guide with parts lists, cost estimates, and clear instructions for your 2011 Chevrolet.

AI Repair Guides



Disassembled Views

Engine Block and Components




1 - Water Pump to Engine Block Seal
2 - Water Pump
3 - Water Transfer Pipe O-ring Seals
4 - Water Transfer Pipe
5 - Coolant Temperature Sensor
6 - Thermostat Housing to Block Gasket
7 - Thermostat Housing
8 - Thermostat
9 - Thermostat Gasket
10 - Thermostat Housing Cap Bolt
11 - Thermostat Housing Cap
12 - Water Pipe Support Bracket
13 - Water Pipe Support Bracket Bolt Stud
14 - Water Pipe Support Bracket Bolt
15 - Cylinder Head Gasket
16 - Piston Ring Assembly
17 - Piston Assembly
18 - Connecting Rod
19 - Connecting Rod Bearing
20 - Connecting Rod Cap Bolt
21 - Cylinder Bore Sleeve
22 - Cylinder Head Alignment Pin
23 - Oil Filter Cap
24 - Oil Filter Cap O-ring
25 - Oil Filter
26 - Engine Block Gallery Plug
27 - Engine Block to Transaxle Alignment Pin
28 - Crankshaft Position Sensor
29 - Crankshaft Position Sensor Bolt
30 - Oil Pressure Switch
31 - Knock Sensor
32 - Piston Oil Nozzle
33 - Engine Block
34 - Crankshaft Thrust Bearing - Upper
35 - Crankshaft Bearing - Upper
36 - Crankshaft
37 - Crankshaft Thrust Bearing - Lower
38 - Crankshaft Bearing - Lower
39 - Crankshaft Rear Seal
40 - Flywheel - Automatic Transmission
41 - Automatic Transaxle Flywheel to Crankshaft Bolt
42 - Manual Transaxle Flywheel
43 - Manual Transaxle Flywheel Bolt
44 - Lower Crankcase
45 - Lower Crankcase Perimeter Bolt
46 - Engine Oil Pan Alignment Pins
47 - Engine Oil Pan
48 - Engine Oil Pan Long Bolt
49 - Engine Oil Pan Bolt
50 - Engine Oil Pan Drain Plug
51 - Lower Crankcase Main Bearing Bolt
Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro
← Back to LocationsAll Makes

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.