System Specifications

This is the exact OEM manual section for the path above. Use the breadcrumb to move up or down the tree until you reach the precise year, make, model, and subsystem you need.

Need a step-by-step guide?

Get an AI-powered repair guide with parts lists, cost estimates, and clear instructions for your 2010 Chevrolet.

AI Repair Guides
Primary Camshaft Drive Chain Tensioner Bolt 25 Nm (18 lb ft)
Secondary Camshaft Drive Chain Tensioner Bolt 25 Nm (18 lb ft)

Crankshaft Balancer Bolt
First Pass 100 Nm (74 lb ft)
Final Pass 150 Degrees

Front Cover Sequence:





Engine Front Cover Stud 15 Nm (11 lb ft)
Engine Front Cover Bolt - M6 15 Nm (11 lb ft)

Engine Front Cover Bolt - M8
First Pass 20 Nm (14 lb ft)
Second Pass 20 Nm (14 lb ft)
Final Pass 60 Degrees

Engine Front Cover Bolt - M12 65 Nm (48 lb ft)
Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro
← Back to Timing ComponentsAll Makes

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.