Transmission Control Module Scan Tool Information (4T45)

This is the exact OEM manual section for the path above. Use the breadcrumb to move up or down the tree until you reach the precise year, make, model, and subsystem you need.

Need a step-by-step guide?

Get an AI-powered repair guide with parts lists, cost estimates, and clear instructions for your 2009 Chevrolet.

AI Repair Guides
Revenue RailIntent: manual

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

More supporting gear

Torque wrench

Use the factory procedure with the right tightening tool.

Manual-based work becomes much easier when you can torque correctly.

Shop on Amazon →

Trim tool set

Useful for clips, covers, and trim pieces called out by the manual.

Most manual procedures assume you have a good trim removal kit.

Shop on Amazon →

Multimeter kit

Great for electrical troubleshooting and manual-tested circuits.

Electrical work in manuals often needs a meter more than another wrench.

Shop on Amazon →



Transmission Control Module Scan Tool Information (4T45)

The Transmission Control Module Scan Tool Data List contains all transmission related parameters that are available on the scan tool. The list is arranged in alphabetical order. A given parameter may appear in any one of the data lists, and in some cases may appear more than once, or in more than one data list in order to group certain related parameters together.

The values below represent a typical display recorded from a properly functioning system.

Important: Do not use a scan tool that displays faulty data. Report the condition to the scan tool manufacturer. The use of a faulty scan tool can result in misdiagnosis and the unnecessary replacement of parts.

Only the parameters listed below are used/referenced in this manual for diagnosis. If a scan tool displays other parameters, those values are not recommended by General Motors for use in diagnosis.

If all values are within the expected range described below, refer to Symptoms - Automatic Transmission (- Symptoms - Automatic Transmission) for diagnosis.

The scan tool values from a properly functioning transmission may be used for comparison with the transmission you are diagnosing. The values below represent a typical display recorded from a properly functioning system.

























← Back to Scan Tool Testing and ProceduresAll Makes