Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Power Window Reinitialization
This is the exact OEM manual section for the path above. Use the breadcrumb to move up or down the tree until you reach the precise year, make, model, and subsystem you need.
Need a step-by-step guide?
Get an AI-powered repair guide with parts lists, cost estimates, and clear instructions for your 2009 Chevrolet.
Power Window Reinitialization
The reinitialization of the power windows will be necessary anytime a door module has been disconnected, replaced, or the vehicles battery has been disconnected or discharged. The power window will be reinitialized when the door module learns the full up and full down positions.
To reinitialize a power window:
1. Close the door for the window being reinitialized.
2. Turn ON the ignition, with the engine OFF.
3. Run the window to the full up position and hold the switch continuously for a minimum of 0.5 seconds.
4. Run the window to the full down position and hold the switch continuously for a minimum of 0.5 seconds.
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.