Function 05 - Erase DTC Memory
Need a step-by-step guide?
Get an AI-powered repair guide with parts lists, cost estimates, and clear instructions for your 2006 Audi.
General Information
The new seat adjustment with memory generation features On Board Diagnostic (OBD) capability. The control module for seat adjustment with memory is equipped with a DTC Memory.
Malfunctions occurring in monitored components/wiring are stored in DTC memory together with an indication of the type of malfunction.
If any control elements are replaced they must be adapted and a basic setting must be initiated => [ Seat Control Element, Basic Setting ].
On Board Diagnostic (OBD), initiating program
Test requirements:
• Voltage supply and fuses for appropriate systems OK.
• Connecting scan tool (VAS5051) => [ VAS 5051, Connecting ] VAS 5051, Connecting
• Switch ignition on.
• If no display appears, use wiring diagram to check power supply for (VAS5051)
• Additional operating instructions can be called up by pressing the Scan Tool HELP button.
• The next step in the program sequence can be selected by pressing the -> button.
• Incorrect entries can be terminated by pressing the C button..
- Switch on printer by pressing Print button (indicator lamp in button lights up).
- Press button 1 for "Rapid data transfer".
Indicated on display:
Rapid data transfer HELP
Enter address word XX
Function 05 - Erase DTC Memory
• If DTC Memory cannot be erased, check DTC Memory again and eliminate malfunction.
Prerequisite
• DTC Memory checked
• All malfunctions corrected
After DTC Memory interrogation:
Implementing Function, 05 - Erase DTC Memory
Indicated on display:
Rapid data transfer HELP
Select function XX
- Press buttons 0 and 5.
Indicated on display:
Rapid data transfer Q
05 - Erase DTC Memory
- Confirm entry with Q button.
Indicated on display:
Rapid data transfer ->
DTC Memory is erased
DTC Memory has been erased.
- Press the -> button.
Indicated on display:
Rapid data transfer HELP
Select function XX
• This message indicates an error in the test sequence.
Warning! ->
DTC Memory not checked
• This message indicates an error in test sequence.
Rapid data transfer ->
DTC Memory not checked
• Follow test sequence exactly: First check DTC Memory, if necessary eliminate any faults, then erase DTC Memory.
• After erasing DTC Memory, implement End Output with function 06, switch ignition off and on again, then re-check DTC Memory.